What You’ll Need:
- Xhibit device
- Network with wireless access (WiFi connection)
- USB mouse
- USB keyboard
- Display device
Connecting to your Network
- Press and Hold CTRL + W (this will close the running content).
- Press and Hold CTRL + ALT + T (this will open a terminal window).
- Type xstop and press ENTER.
- Hover over the top right corner of your screen. Then click the up and down icon to see your Wi-Fi network.
- NOTE: If you do not see the toolbar at the top of your screen, press ALT+TAB on your keyboard to temporarily switch away from your signage. Your signage may re-open after 30 seconds, but you can press ALT+TAB once again to switch away from it and continue the Wifi setup.
- Click on the name of your network and enter the password to connect your device.
- NOTE: If you have not yet changed your password or simply do not know it, the manufacturer has a default password on the wireless router that you can enter in. It can be found on the bottom or on the back of the router.
- Once you have successfully selected your network and entered your password. Then, follow step 2 above, then type: xstart (and press ENTER).
After completing these steps, the firmware should load and within 10-25 minutes begin displaying content. The time it takes for the firmware to launch on the Xhibit hardware is highly dependent on the current state of the network; where the device is installed and connected.